MOT & FULL Servicing

.

Checks carried out:

Fit seat cover & floor mat

Drain oil & refill

Replace oil filter

Check for general oil leaks – report serious leaks

Check for timing belt replacement interval & report

Check radiator condition & security & report

Check the condition of the radiator cap

Check coolant hoses for leaks & condition, check securing clips for tightness & report

Visually inspect expansion tank for leaks & cap security

Check electric cooling fan for operation where applicable

Check condition & tension of serpentine/Auxiliary belts (not timing/cam belt)

Replace Air filter

Replace spark plugs (if applicable)

Drain & replace coolant (when required)

Check fuel cap condition

Replace fuel filter (unless long life in-tank filter)

Check visual conditions of fuel lines

Test effectiveness of starter motor

Test alternator charge rate

Check & report engine mountings

Check & report gearbox mountings

Check clutch operation

Top-up transmission fluid (Auto)

Top-up gearbox oil (manual)

Drain & replace brake fluid (when required)

Check driveshaft gaiters & report

Check prop/driveshaft/joints & grease nipples where fitted

Check & top up axle &/or transaxle oil (if applicable)

Check operation of exterior lights

Check operation of interior lights

Check headlamp alignment & advise

Check horn

Check diesel heater plug indicator operation where fitted

Check battery security & lubricate terminals

Top up battery (where applicable)

Visually inspect HT leads /distributor cap/coil pack(s) (where applicable)

Check/top-up PAS fluid reservoir

Check steering/suspension components for wear & corrosion

Check steering rack gaiters condition & report

Check wheel bearings for excessive noise &/or play

Check shock absorber condition & report any leaks as necessary

Grease steering/suspension

Inspect exhaust system for leaks, supports & corrosion

Visual smoke check (diesel only)

Check brake pads for wear & report

Check brake callipers for fluid leaks & security

Check brake shoes for wear (if applicable)

Check brake load sensing valve for operation &/or leaks

Inspect wheel cylinders for correct operation & leaks

Visually check brakes hydraulic system for leaks & report

Check parking brake linkages & travel & report

Check brake discs/drums for wear, corrosion & pitting & report

Test & report brake fluid boiling point

Check brake servo operation

Check anti-slip pedal rubbers

Check for warning lamps & report

Remove wheels

Check tyre size & fitted according to sidewall instructions

Check tyre condition & tread depth & report (see overleaf)

Check & adjust tyre pressures as necessary

Set wheel nut torques to correct setting

Check windscreen wipers (front & rear) condition & report

Check windscreen washer operation & top-up if required

Check windscreen for chips/cracks

Check wing & interior mirrors condition

Check number plate condition

Check pollen/cabin filter condition & report

Check all seat belts

Check Air conditioning efficiency and advise

Lubricate all door hinges

Lubricate bonnet catch

Reset service indicator (subject to data)

Stamp service history record

Remove seat cover & floor mat

Wash & Vac service

MOT Included